SlipLok case
Added 2025-11-03 18:19:55 +0000 UTC Hello members, new and old.
Here is the SlipLok case!
This one's for 256x256 and larger build plates, such as on the Bambu, but I'll split it up for smaller ones in the next day or two.
I'll send it to everyone who was a member this month by MyMiniFactory at the end of the month :-)
Until then, enjoy!
Comments
It's intended as more of a display case so the plasticars is recommended but I will make alternatives, yes.
Iain Davies
2025-11-04 06:10:59 +0000 UTCThe instructions say the plasticard is optional but without it the case is open; I’m guessing one of the additional faces will be solid and not a frame?
Otis Viles
2025-11-04 03:36:43 +0000 UTCTap A for auto-arrange. It'll put it in the right place.
Iain Davies
2025-11-03 18:49:11 +0000 UTCHi, Thanks for sending. I have a P1S and I’m getting an error on the case.stl that it’s to close to the exclusion area.. Thoughts? Thanks, Howard
Howard Katz
2025-11-03 18:45:02 +0000 UTC
