A little more from the vibraphone!
Added 2024-05-12 11:45:37 +0000 UTCfull video on build up tomorrow! :) will be tackling the brushless motor in the next installment when rewiring the glockenspiels!
Comments
I wish I had seen this video before I visited the Museum, so I could appreciate this piece of hardware!
Mike in Texas
2024-05-13 23:08:01 +0000 UTCYeah, I'll be there with an industrial robot arm. I use the ODrive on my mill that I took last year, they are super quiet and use very little power. The axes on my mill run at 500mA at 12v, but have tons of power capacity. The ODrive has a step/direction input too (well the old one did), so just swap out. My mill has HTD drive belts to reduce speed/increase torque. I have a couple of bits for your museum, one is a circuit board from the Open University back in the black and white days.
Neil Devonshire
2024-05-13 18:52:06 +0000 UTC
