A Mothers Light - Cubone Skull
Added 2022-05-02 19:33:51 +0000 UTCFor FDM
.12
If you use the full skull I would sink its about 1mm into the print bed to make sure it gets a good grip
Use Supports - I would use tree
Brim
If you do the halfs
.12
Use Supports - I would use tree
resin angle and print.
Comments
done https://www.patreon.com/posts/cubone-release-57744065
Kenneth Loebenberg
2022-05-21 13:56:10 +0000 UTCThis is awesome! Will you make the rest of Cubone?
Makerwiz
2022-05-21 12:42:38 +0000 UTCThat is so amazing <3
Lyrinta
2022-05-02 19:56:51 +0000 UTC
