WIP - Clamp with larger plates - download available!
Added 2019-12-18 14:23:02 +0000 UTCHey everyone! And welcome (and thank you!) to those of you who've just signed up! I thought I'd throw this design up, even though I'm only just about to go print it off now, myself! As you've probably worked out, it's an update to the print-in-place clamp, and it's intended to:
1) Provide a larger clamping area
2) Print more reliably by removing the relatively narrow piece that is prone to falling over.
Have a look at the red circled bit in this comparison of the existing vs revised design:
So, Creative Printer tier supporters, you'll find this model in the same dropbox directory as the original version. My test print is only just starting, but if you want to throw caution to the wind and risk a little wasted plastic you're more than welcome to give it a try right now! :D
