Support Settings
Added 2021-01-15 15:29:01 +0000 UTCHey Everyone! Few more days for the rest of the wracked warrior poses release, I'll be showing a sneak peak tomorrow, but till then, I had some people ask about the support settings I use in chitubox. They are a combination of lots of experimenting and checking others peoples settings. For light supports, I stay between an upper diameter of 0.10 and 0.20 depending on the size of the piece. Medium and large usually stay the same at 0.30 and 0.60. I also tend to change the contact depth when the support passes through the piece but that's it! Hope it helps :D Also we're almost at 100!! Exciting, I've started working on the Acothyst, it's going to be awesome :D
Comments
haha sawed off handles! yeah, nothing a small beefen of the chitubox can't fix! :D sorry I'm just seeing this comment now haha thanks for the feedback!
2021-02-04 11:11:39 +0000 UTCThe supports have been amazing - printed all the monstrosities and wracks without any issues (LD002R @ 7.5secs with Eryone resin) Only things that have not printed correctly is the bottom of some of the weapon handles on the "group plates" - most of them are still usable though just slightly shorter than they should be!
2021-02-01 11:16:47 +0000 UTCAweee my man! Love to hear it! haha yeah I did that a few times too, nothing abit of glue can't fix. Damn now that's an army! Let the raiding begin! :D
2021-01-21 07:18:17 +0000 UTCI just printed out about 20 Wracks and 4 Grotesques (I mirrored some wracks for even more poses) I must say your supports are right on. The only failure I have had was when I broke a foot off (my fault) Great design and great supports. Thank SO much!
DeMon
2021-01-21 07:09:09 +0000 UTC
