Down to the wire... again
Added 2022-06-28 23:23:50 +0000 UTCBest case scenario I get it all cut apart and supported tomorrow
Worst case - Thursday, but lets keep our fingers crossed for Wednesday
All good?
Comments
Maryo or DMG.... how'd the print come together? I am getting ready to test print before it goes up on the store (after jury duty today) and would love to know how others faired before I tie up some printers. Thank you!
Clint D.
2022-07-05 13:06:53 +0000 UTCyep - a bit of an experiment... did the ball fit tight? or was it too loose to hold?
Chad Hoverter
2022-07-04 15:57:42 +0000 UTC
