Ebike 4.0 Rear Pulley
Added 2018-08-01 16:00:36 +0000 UTCThis was a bit of a pain to fit due to the disk brake caliper being only 6-7mm from the wheel spokes. So the pulley has to squeeze between the spokes and the caliper, then bend back around the caliper to allow the belt to run past the tyre. On the plus side, the CNC is cutting aluminium very well!
Comments
It's pretty close haha!
Tom Stanton
2018-08-01 16:23:32 +0000 UTCIncredible!
Logan Vinson
2018-08-01 16:23:13 +0000 UTC<img src="https://c10.patreonusercontent.com/4/patreon-comment/eyJ3IjoxNjAwfQ%3D%3D/whWu5AZjQgvYwvb13XOKR8rHkiDEOGJFz2aMsYlWqwVNXQ67CiQNJpViQGlI9xnN.jpg?token-time=1701388800&token-hash=6oTDwMfl17MaqC3C3qdldBXPlJSt-mxXetz_RCMmmtA%3D">
Tom Stanton
2018-08-01 16:23:06 +0000 UTCTom Stanton
2018-08-01 16:22:14 +0000 UTC<img src="https://c10.patreonusercontent.com/4/patreon-comment/eyJ3IjoxNjAwfQ%3D%3D/PIdJP2W03I4vrcUCFdoFK5z8SWDdLVy_moMfpAVMYaz0GsLn3r6ODkIB3JefIjLG.jpg?token-time=1701388800&token-hash=jcCXJDZnwDMvzDTwF2hCzkSFgkbDUp5ObU4Wt0JR91U%3D">
Tom Stanton
2018-08-01 16:21:39 +0000 UTCRegardless, congrats on squeezing that into such a tight place!
Logan Vinson
2018-08-01 16:20:09 +0000 UTCHow are your clearances? Did the caliper allow for enough play?
Logan Vinson
2018-08-01 16:19:21 +0000 UTC
