exFW880 V6
Added 2025-07-03 20:00:05 +0000 UTCThe next exploratory firmware. This time it's a rudimentary simplex VFO. You have bandwidth, modulation, frequency, rssi/ex-noise readouts and simple noise based squelch. Pretty basic but enough to gauge RX/TX performance across the bands.
To the best of my knowledge, the correct TX/RX filters/finals are being engaged.
Controls:
0-9 : Enter new frequency
Menu (Green) : Enter new step
UP/DOWN : Step frequency
* : Toggle Bandwidth
# : Toggle Modulation
S1: Toggle squelch override
S2: Toggle Antennas
PTT: Transmit
LP1: Edit TX Power Gain 1
LP2: Edit TX Power Gain 2
LP3: Edit TX Power Bias
Comments
Yes it is. Can you get power out on the previous diagnostic firmware on 6m? If so, which configuration do you have to use.
Marcus Dudley
2025-07-13 07:58:16 +0000 UTCmarcus, is the line tx29/50 used in this POC? cant get power at 51Mhz (like in the stock firmware)
Ramon Martinez Palomares
2025-07-13 07:38:39 +0000 UTCTesting V6.... Works far better than stock firmware. i am enjoying if (two qso. one in 144 and another in 28Mhz)
Ramon Martinez Palomares
2025-07-04 12:04:57 +0000 UTC
