Jade MK latex tutorial
Added 2019-05-31 16:53:42 +0000 UTCHere is my Jade tutorial:
Started off drafting my pattern
Leotard front and back, Stocking and arm band. I cut all these into sections and colour coded them.
Stockings:
I added 1" gold running strip along the middle and top, I find it easier to glue while the stockings are flat.
Gently place the green diamond on top.
Only one seam centred on the back.
Arm band: cut into sections, this gave a nice layered effect!
Cross detail panel on the back, I used 0.40mm trans latex and glued 1cm strips on top.
Mask I made up a pattern too, Split into half which I do this to all my patterns. So it's all symmetrical! Added two 1cm latex strips on each end just like a mask.
For the Leotard I installed a 51cm zip, I use this length with all my leotards.
Glued front to back first, then joined the side seams, finally gluing the crotch together.
For the chains, I added a loop inside and hooked a jump ring so the chains can be attached. This can also be removed at any time!
For the chest crosses I glued strips which are attached inside, shown in the photo below:
Here's a photo of me gluing her upper arm band.
The sash is separate, believe it or not!
I hope you enjoyed my little tutorial how I made Jade, any questions? feel free to ask!
I have some more tutorials to share in June :)
Comments
Love this, just shows how much goes into each outfit, and makes me even more in awe of your creative genius 😍😍
2pintspete
2019-05-31 17:07:39 +0000 UTCThank you, this tutorial is super helpful!
Skotti Kimble
2019-05-31 17:06:38 +0000 UTCLoved this set. So cool to see how you do your work and look so HOTT after wards
Spartan1337
2019-05-31 16:55:03 +0000 UTC
