November Drop #2
Added 2023-11-15 19:01:10 +0000 UTCHello everyone!! We have a fun mix of items here. I actually have a couple more that I am finalizing, but I did not want to delay the drop. A couple of things, the last several weeks I have been preparing for a few shows. I was limited on printers for test printing, and at times I ran out of colors needed, so you will notice some of the colors seem a little off. We have over 25 files in total in this drop, mostly Christmas heavy, but I tried to add some non-christmas ones.
I will be adding some of these on MakerWorld and Cults in order to help promote the Patreon a bit. Hope you guys enjoy this drop. The other file I am working on will likely be released this week.
Pins, coasters, keychains, wall art- Remember most of these can be scaled to fit whatever need you want. I always try and do at least one of them with all those options in each drop so you can use it as a template. If you want double sided items, just remove the "rear" object that I added. I did the holes for the key chains so you can remove them in BS if you want them as pins. In those cases, you will want a solid back to reduce waste since the back will not be visible. You can either add the rear file in the folders, or, you can pain it black in BS.
Face down prints- I use 0.16 for the first layer, 0.2 for the rest, arachne walls, 4 bottom layers and for anything coaster size and down I do 100% infill. 10-15% infill for larger items. I also at times will switch to a lower first layer speed if I need to. OR if you do not mind the extended time, you can switch to a 0.2 nozzle for finer detail. NO brims or supports on any of these.
Remember to use good filaments, settings, and a clean bed to reduce any wisps.
FB Patreon group: https://www.facebook.com/groups/585869610371951
Command strips for wall art: https://a.co/d/60qT5A8
Google Drive for files: https://drive.google.com/drive/folders/1nWdCe-v-amVX_oIGBOKqR3FgfchkV8XM?usp=drive_link
