eastman

DARKSEID

Added 2021-03-23 17:35:08 +0000 UTC

So this here Darkseid guy is an easier print than the two previous releases since there are only two pieces (back to basics) that should print fine without supports (unless you print in resin). Of course if you know your printer is notoriously bad with overhangs it wouldn't hurt to put some supports under his jawline :)

This time around I didn't take any pictures of my resin print because frankly I was both disgusted and embarrassed by how I had done the supports as I was trying out something new. Just to paint you a picture, try imagining some idiot placing a support every 1 mm or so on the entire flat surface and then having them almost fusing together, resulting in me spending 20 minutes hacking away at them with flush cutters and knives. The eagle eyed observer can see a crack that have been fixed with glue and baking soda...

Shudder.

Have fun printing! I have to get back to finishing up the next one (which will be related to a certain TV show that will be premiering this Friday (I'm so bloody excited)).