RELEASE: Rogue Bust
Added 2019-12-18 00:49:18 +0000 UTCFile is available for my Supporter tier patrons and can be found via Dropbox here.
So here she is: Rogue!
I was convinced I would be able to release her sooner than this, but I kept doing some changes here, and some changes there, and I remade her face after some good feedback from Thomas Strande Hansen regarding her being a more haunted character, and not as much the smug grinning one that I had first envisioned. Thanks for that feedback, Thomas!
Printing information
Supports: Yes, a few (see details below)
Infill: No
Supports
She comes in two pieces as us pretty much the standard for me these days: a body, and a base. I did a lot of work getting her as printable without supports as possible. I even did that dumb thing where I tilted her head back a bit too much, but in the end I made the decision to have her require some supports on her arms, because the one thing I did like about this sculpt his her pose, and while I'm sure I could have forced the geometry into something that would have been more support free, it wouldn't have looked great, and I decided not to make that compromise.
So you'll need some supports in some strategic places, painted red here:
And I've provided an example of custom supports places in Simplify3D here:
Infill
Not needed! But I'd add some just because, but that's just me :)
THANKS
... for your continued support, it means a lot, and I hope to keep living up to your expectations for many more creations to come!
