JOKER release!
Added 2019-08-27 12:57:07 +0000 UTCClick here for current Dropbox download link (Supporter and up tiers)!
Hello, gang! Took a while to get this one ready due to some things going on behind the scenes, but Mr. J has finally arrived!
He does require some supports this time around, I just didn't see a good way to get around it, but I've designed it all to keep them to a minimum so you should only need to use a pillar under his nose, and under his chin.
Using your slicer of choice you'll want to place them kind of as indicated in these images. :
When it comes to infill, you'll need to use your own discretion on this because slicers seem to handle this differently. What usually works fine for me is 10% rectilinear infill, but again, please use your own experience with your own printer and slicer combination since I can't guarantee what works for me will work for you.
Infill shouldn't really be needed up until the neck (as indicated in picture below), but please do scrub through the layers in your slicer and make sure nothing is printing too obviously in the air. Again (yes, I know, I keep repeating this) use your own knowledge and experience to determine what will work for your printer and slicer :)
Finally, thank you for sticking around, despite me being very quiet this month, but I hope it will have been worth the wait! Things are mostly sorted on my personal end, so I expect to be back at 90% capacity as of today.
I also have a huge backlog of social media to go through, so please bear with me while I slog through it!
Again, thank you for your continued support!
