ThinAir3D

American Flag Challenge Coin Display

Added 2024-04-16 21:50:41 +0000 UTC

Hey everyone!

I've had a few member requests for new challenge coin displays. Someone specifically requested an American Flag design, so here we have it! This design prints in separate pieces and is meant to be glued together afterwards. It has holes in the back for wall mounting, and printable feet for table-top display.

*Important Note: I wanted to maximize the storage on this design so it maxes out a Bambu P1S/X1C build plate (256x256). If you have a printer smaller than that, you may need to scale the design down which could cause issues with larger coins fitting on the shelves.

I have included a Bambu .3mf file so you can just import and print the different plates. The longer pieces need to be printed at a 45 degree angle to fit, with the back plate printing on its top face.

Below you will find the print files and print instructions, but you can also find them in the archives!

As always, I hope you like the design and thank you all very much for the support!

- Jacob