Christmas Lightbulb Ornament/Container
Added 2023-12-02 18:13:38 +0000 UTCHey everyone!
This is the Christmas Lightbulb Ornament/Container. This design prints in 2, support-free pieces that thread together afterwards. The cap has a hole cut through so you can route thread through for hanging!
The "lightbulb" portion is hollow, with an opening of about 30mm so it can be stuffed with small candy or other things. The entire design prints in about an hour on my Bambu printers!
You can find the STL's and print instructions attached to this post, as well as in the Google Drive Archives!
As always, thank you all very much for the support and I hope you enjoy this model!
- Jacob
Comments
Well count me in as excited!
Christopher Kirby
2023-12-09 11:29:20 +0000 UTCFunny you mention that... I'm actually working on 2 different fidgets right now, one of which is a gyro fidget. With the gyro i'm really just fine tuning/tweaking to get the beste spin possible
ThinAir3D
2023-12-09 11:26:39 +0000 UTCYou should do some more fidgets! I use the bolts for purge, but want a really good gyro fidget to purge.
Christopher Kirby
2023-12-09 06:36:05 +0000 UTCSorry ended up reading your PDF and it says it will scale up and thread just fine. That was my concern
StarlightFoundry
2023-12-03 03:34:21 +0000 UTCDo you mean what size to scale it at? I'm confused
ThinAir3D
2023-12-03 02:48:46 +0000 UTCSuggestions on scaling it to full print bed size?
StarlightFoundry
2023-12-02 18:15:31 +0000 UTCHa! I have literally just been looking for light bulb things!!!
StarlightFoundry
2023-12-02 18:15:00 +0000 UTC
