Reverse Bodwen (rail setup only) - uses mini pneumatic clips
Added 2023-02-27 00:37:52 +0000 UTC
I will see if I can make a new X motor mount for wheel setup that can accommodate the same thing
the model for PC4_M6 needs a small 9.5~10mm ptfe tube sitting between the two pneumatic pieces (PC4_M6), also it's may be needed for carve out the end of the ptfe tube in a funnel shape to help guide the filament in case of small misalignments when you feed it.
Also It's best to get larger inner diameter ptfe tubing meant for 2.8~3mm filament ( but still 4mm outer diameter) to reduce friction. Unlike a Bowden setup this is just for guiding filament cleanly.
only place to keep smaller "normal" ptfe is between the direct driver extruder and hotend.
Comments
Just added it, filename with PC4_M6 pneumatic coupling :) printing it now to make sure it works, but if too tight or too loose don't hesitate to let me know, and I can adjust it.
Squirrelf
2023-03-02 03:11:12 +0000 UTCWould it be possible to create a version of this that uses pneumatic couplers like the one in the Sunlu adapter? They are much easier to find here than the pneumatic clips.
2023-03-01 19:30:57 +0000 UTCOh that was a quick design I made a while back and forgot to post it ( most of them broke, but that one lasted ) I will find it an post it a bit later
Squirrelf
2023-02-27 15:09:26 +0000 UTC
