XaiJu
thedroneracingengineer
thedroneracingengineer

patreon


MEETUP LOCATION for Houston TX TODAY

The location for today's meetup with me and the other Rotor Riot guys will be 4 PM today at Bear Creek Pioneer's Park. We will set up at one of the pavilions just show up and listen for the quads.

Comments

Just saw this comment... I sent you an email Josh

that is very unusual. Will you please email me to discuss?

Joshua Bardwell

Like, literally if you set it down it doesn't work but if you pick it up, it does work?

Joshua Bardwell

Any reason why an fc would just shutoff and die (won't light up now) if I put the quad down on a metal surface ? Motors are naked bottom so I'm 100% sure there are no screws in the windings... I'm totally stumped by this one

Appreciate your content. I'm done with patreon, I hope it folds. Good luck to you josh you are a amazing human.

Like ships in the night...

Joshua Bardwell

Wish I would have know sooner its a 7 or so hr drive to get there. Last time we in the same town was San Diego I had just got there and I reached out to ya on Facebook. You told me about TODAI restaurant and the night race...

Yeah, right on Jake. You need to swap the motor wires not the ESC wires. I put the BADASS 2205 2450 kv naked bottoms on my wizard and I had to go in BL Heli suite and switch them.

You were almost there - you needed to swap 2 of the 3 motor wires, NOT the black and red wires. Hopefully you didn't fry the ESC.

I have a question. I have an F7, 4 emax 30a bullet esc, 4 emax 2313 935kv. All 4 motors spin the same direction. I tried reversing the red and black wires between the esc and fc which causes a short. Is the only way to reverse those 2 motors by using belheli suite? I’m in the military on the go so I only get to work on it in short sessions.

Dang, I’m in Dallas on work travel. Would’ve brought the quad had I known you’d be out here.

Have fun :)

U guys have fun. Wish I could make it.

Have fun!


More Creators