Pikachu Now Available!
Added 2021-12-28 03:26:41 +0000 UTCAfter a succesful test print, Pikachu is now available to any Patreons! Stay tuned for the next one!
https://drive.google.com/drive/folders/1d4G46eiCiQy6pBVldO3JVT-iD2ZxrDZL?usp=sharing
Comments
At 45% that's probably just over an inch tall right? I'd say you'd have to go up a bit ya. Are you making them into keychains?
Mike Hammond
2022-01-05 11:37:22 +0000 UTCUpdate: So i assume i just need to print them at a larger scale because at 45% my lightest support was stronger than the tail. So i will try again, only larger
Philip D'Angelo
2022-01-05 06:50:04 +0000 UTCI printed them at about 45% scale and they look great, i probably did them too small because the tails are sooooooo fragile at that size. i printed 6 at the same time, broke one tail getting support off and then decided to fully cure them and ill try again once they have hardened a little more.
Philip D'Angelo
2022-01-05 06:34:49 +0000 UTCCan't wait to see them!
Mike Hammond
2022-01-05 04:07:58 +0000 UTCGetting ready to throw a few of these small guys on my resin printer!
Philip D'Angelo
2022-01-05 03:58:15 +0000 UTC
