XaiJu
vizguru
vizguru

patreon


Photogrammetry pt. 2

Finally I could finish this part. Part 3 is also already recorded, I'll edit it and upload tomorrow! :-)

Comments

I think the alignment process in Agisoft works so smooth and quick that it's probably not worth the hassle. I did that solution with my automated photogrammetry scanner, where it shoots from below to all the way up from top. It saves scanning time, but not very much processing time. But in later videos you'll see that I switched to Reality Capture and there you usually don't have to care about alignig chunks at all as it does it all automatically (if done right) :-)

For aligning chunks, would you actually recommend to try getting everything in one chunk(say finding a way to put the object on pole or something and have the camera tilt up to shot photos of the the bottom) instead of spending all the manual work to match the position and delete overlapped points clouds?

Sorry, totally my mistake, now corrected. :-)

Thanks a lot for sharing your experience with metashape. Great content as usual. But why is pt. 3 not available for "video + article patreons"? ;)


More Creators