WIP UPDATE: Sora Kingdom Hearts
Added 2024-09-26 22:47:16 +0000 UTCHi patreons.
I share with you the preview of the Sora model from Kingdom Hearts, this would be the preview of the model. I hope you like it
Comments
Thank you very much, I just uploaded pre-supported files for the riku model, although personally since I started printing I have never printed pre-supported files because there are different types of resins, and printers with FEP, NFEP or ACF are variables that must be consider to see if your supports can be thinner, or if the contact surface needs to be larger so it doesn't come off. That's why I prefer to accommodate the supports and not the pre-supported files, however, it is not that complicated, most of the time it works with the automatic supports of the program, whether they are thin or intermediate, depending on your printer, the complicated thing is when You hollow out the pieces because you have to place the drains well to avoid suction. You should try it, it's always good to know our printers. But you can still try the files I uploaded, they are the ones I used for my printer, but I cannot assure you that they are the optimal configuration of supports for your printer, they may be difficult for you to remove from the model or fail in some way.
Chanito Zepeda
2024-09-28 04:02:02 +0000 UTCI love your models so much! 🥰 I want Riku and Sora, I have Roxas...But I suck at supporting stl files...*noob* Do you think you'll pre-supported them one day? If not, have you any suggestions/tips for learning "easily" how to supports? Thank you 👉👈
HimeRose
2024-09-28 00:12:29 +0000 UTC
