Wonder Woman full statue RELEASE
Added 2019-07-07 13:30:19 +0000 UTCDROPBOX LINK here for Supporter/Kingpin tiers.
HERE SHE FINALLY IS, the full figure Wonder Woman :) This is a release for the Supporter and Kingpin tiers. She is primarily designed to be printed in parts, as shown below, and then assembled, as also shown below.
Print settings
Supports: None
Infill: 10% rectilinear works fine, but as always I recommend looking at the model in your slicer and scrub through the layers to make sure there aren't a bunch of internal overhangs printing in the air. If you have questions about this drop by the patron Discord, or drop me a message here :)
Remember to check out the Read Me First!.pdf file you can find in the folder!
DROPBOX LINK here for Supporter/Kingpin tiers.
Other versions
Resin version
I have a folder with a resin version, so check that out if you plan on printing in resin. The difference is the body is separate from a keyed base, so you can easier print her laying down, or tilted, without the base getting in the way too much, and then put the two pieces together.
One solid piece version
Important: Someone always asks for a full, solid, one piece version of the model, so I have included one as well in a separate folder, but I wholeheartedly do not recommend printing it as is, because it is just not designed for that and will require an ungodly amount of supports. BUT. It is good to have in case you want to cut the model up into pieces yourself.
And last, but not least...
Thank you for your continued support! These models would literally not exist without you guys and gals :)
