eastman

Wonder Woman, update

Added 2019-06-30 22:45:29 +0000 UTC

She is basically, kind of, almost done. I had to replace the lasso in her hand with the shield to make her print reliably, because the rope kept failing every other print. When putting her together I did notice she is a bit off balance leaning forward, so I want to adjust that, as well reposing the fingers holding the sword slightly, and a few really minor annoyances.

I'll make some variants with a tall base as well as a flat one, and you will also get the full figure if you want to slice her up yourself

I'l

As you can tell below I've done some extensive test printing on her, much more than I have previously.

As I am away from home this week, you will be able to print her on Sunday the 7th of June. I'm sorry I wasn't able to finish her before then, but this is my first full figure of any complexity and it needed to not be rushed!

As always I am grateful to you for your continued support and faith in me and my sculpts, and I hope summertime is treating you well. Remember to stay hydrated, keep your printing space well ventilated, and check the wires on your 3D printers once in a while. Stay safe!