Skull Keychains!
Added 2022-09-29 18:06:29 +0000 UTCHey everyone!
Here is one last variation to add to our Halloween Skull Pack, keychains! As with the rest of the skull variations, these print with no supports needed.
I have uploaded two versions of the keychain into the Archives. (1) A plain skull version and (2) skull and crossbones version.
These are designed at a fairly small scale so you may not want to scale them any smaller, but should be fine to scale up if you choose!
Here is the link to them in the archives if you would like to print them!
https://drive.google.com/drive/folders/15EsrSRqEGgzXw8zc_fCiEsqElMcGjR91?usp=sharing
As always thank you all very much for the support, hope you like the keychains!
- Jacob
Comments
Sorry about the issue!
ThinAir3D
2022-10-12 13:34:52 +0000 UTCHey! Did you download it right when I released it? That was a mistake, but I have since re-uploaded a fixed version! If you download it again it should fix it!
ThinAir3D
2022-10-12 13:30:34 +0000 UTCWhen i load the skull and crossbones into my slicers, the crossbones always start on layer 2 and then make my prints fail - should they start on layer 2? I didnt think they needed supports
Makers Ace
2022-10-12 05:00:35 +0000 UTC
