It's Hangout time!
Added 2017-10-06 18:41:23 +0000 UTCHi all,
shall we do another one of the (almost) monthly hangouts this weekend? After TCT (and subsequent recovery), I think this Sunday afternoon at 5PM CEST would be a good opportunity!
You can leave your question for the Hangout as a comment under this post - I'll try to work through them all. There'll be a separate post with the live Hangout link for Patrons in that tier, but the recording will be available to everyone.
Ask away!
-Tom
Comments
A friend of mine has a mk2s and is having trouble with layer shifting hours into large parts, resulting in spaghetti. It's hard to reproduce with small parts so I'm having trouble diagnosing the problem. Any suggestions? Slower travel speeds? Higher current?
2017-10-08 15:36:03 +0000 UTCServus Tom, Is there any difference in buying a XYZ/i3 or delte 3D-printer when you later want to improve the print quality? ie. there are big communities and tons of improvements to Wanhau and probably Anet - is it just as easy and just as much bang-for-your-buck to improve a delta-printer? Thank you for quality content and not just a stream of (insincere) reviews - I like your priorities! My regards from Denmark
Tom Christensen
2017-10-08 14:04:12 +0000 UTC
