Nintendo Switch Storage Spinner (Green Tube)
Added 2024-02-03 20:46:15 +0000 UTCThis switch games storage spins in a super satisfying way! It is inspired by that popular video game you may have heard of with green tubes (;
Selling Opportunity! A version of this that DOESNT EVEN SPIN sells on Etsy for $30. So this could be a very profitable item even with the bearing and magnet cost.
Components you'll need.
1. The Magnets: Small Round Magnets (Amazon) (same magnets as all other prints)
You'll need 22 magnets per spinner
2. Bearings: Fidget Spinner Bearings (Amazon)
You need just 1 bearing per spinner
3. Stick on Rubber Base (Optional): 58mm Anti-Slip Silicone (Amazon)
You need just 1 per spinner
Comments
The magnets have no affect on the games. Switch cartridges don’t use magnetic memory and will not be affected.
ForgeCore Co
2024-02-18 19:23:11 +0000 UTCHello! A question I have about the spinner tube files for Nintendo Switch games. The magnets don't damage the game chips, is the switch? thank you.
Jose
2024-02-18 19:14:58 +0000 UTCOh that’s super long, what printer are you using?
ForgeCore Co
2024-02-15 14:53:44 +0000 UTCWhat kind of average print time are you all seeing for this with the recommended settings? I'm getting 10 hours on the base and 10 hours on the top
2024-02-15 14:50:10 +0000 UTCAny chance you can share your support settings on this one? I'm having some trouble with it
SkysThLimit
2024-02-12 07:11:13 +0000 UTCWhat did you use for the interface material?
TX911GUY
2024-02-10 04:05:14 +0000 UTCHi! Did you try tapping it in with a hammer or mallet? It can take some force
ForgeCore Co
2024-02-10 03:33:41 +0000 UTCthe bearings do not fit into the cap, impossible to assemble
Sherris
2024-02-10 03:32:58 +0000 UTCI really love this design and just sold my first one of it! Also, I did find using pla support filament makes printing the top super clean. Flip over, support interface the support filament, came out as one big chunk.
Kyle Weiss
2024-02-10 03:09:30 +0000 UTCYup exactly the same
ForgeCore Co
2024-02-07 21:26:51 +0000 UTCAll of the parts needed to purchase for this model are the same as the red one correct?
2024-02-07 21:21:34 +0000 UTCIt wont be able to print without supports, you may need to adjust your support settings, mine came right off. You make need to adjust your gap between the supports and model of you’re having a hard time removing it
ForgeCore Co
2024-02-06 11:45:33 +0000 UTCYeah, trying to remove the fine mesh layer on the top is a pain…did you try printing without supports?
TX911GUY
2024-02-06 04:57:48 +0000 UTC
