Sovol SV06 revisited - new rod mount block for Apollo extralock
Added 2024-09-22 20:58:43 +0000 UTCCompatible with apollo extra lock model to be fully secured
and widened to match the apollo.
A bit of print space is lost, about 208mm of printable area in X according to CAD (I don't have that printer)
You would use the Apollo "MainBody ExtraLock" version with this
and the linear rail backplate apollo, as there are matching hole mount.
only did a CAD fit with orbiter2, which would need to have motor forward.
sherpa and other similar extruder might work, but again motor forward
rear motor would likely work with a simple 10mm extruder riser.
and did a fit test for the side mounted Cartographer/Beacon probe which will go on perfectly well
Comments
I am using it with an HGXlite. If stepper is in the back, riser is required, as noted, and you also lose some z height because the stepper will hit the gantry before the x axis blocks.
GF Ragib
2024-09-22 21:04:43 +0000 UTC
