Mark 2 Design

Rock 'n Roll V2

Added 2024-08-12 18:53:35 +0000 UTC

Hey! Just a little sneak peak of one of my projects. I did a 3D design of Rock 'n Roll V2's Gatling guns/ammo pack/ammo belts very early on, early 2021 I think. I didn't have the original items in hand at the time and actually 3D designed the entire thing in Tinkercad. It wasn't bad but was a huge pain in the ass to produce. I was never happy with the material I was using for the ammo belts and shelved the whole thing for quite a while.

Now I'm redesigning it from the ground up in Fusion 360 and zBrush. This time around I am basing the design much closer to the original toy and will be printing the ammo belts in F69 (TPU-like resin). I am working on a secondary shirt for Craig S. McConnel to wear as well as a new head sculpt. I think his hat is key to the version 2 look and there is no way to make one fit on the existing head and not look stupid.

Anywho, these shots are of the first round of test prints. Not bad, just a bit of tweaking to do here. The shirt is a bit of a beast and will likely take some time.

-Mark