Tuning... and tuning... and tuning... and non-linear pressure advance
Added 2025-01-24 18:32:43 +0000 UTCOver the last days I was struggling getting non-linear pressure advance working on my T250. For those who don't know about it it's basic a way of defining a PA value that behaved stronger at lower flows and gets less and less the higher the printing flows get. It's completely bleeding edge, no documention, no best practices but im confident that with non-linear PA the boundaries of high speed printing will shift further. But since there's not much documentation and things develop really slowly so today there is no fancy announchment to make, no outcome I created only a lot of output in the form of melted plastic
